Gasket Maker

This product has excellent adhesion characteristics and high chemical resistance. Will not sag or shrink and is impervious to temperature extremes.

Note: NOT recommended for use on cylinder heads, exhaust manifolds, intake manifolds, carburetors, or continuous immersion in gasoline.

Forms in-place gaskets for:

• Oil and transmission pans

• Gear boxes

• Oil and water pumps

• Compressors

• Valve and timing chain covers

• Machine covers

• Electric motors, electrical control boxes, and more

• Specifically designed for all oxygen sensor equipped vehicles

Directions:

Surface must be clean, dry and free of oil, tar, dirt and dust for best adhesion. Hold can at 45° angle and apply a continuous bead of 1/16” to 1/8” to the mating surface, encircling all bolt holes. For adhesion to both parts, assemble immediately.

One part adhesion, allow 10 to 15 minutes for bead to skin. Assemble parts, but do not squeeze gasket out by over tightening bolts. Starts to cure immediately, fully cures in 24 hours and reaches optimum strength in 7 days.

Quantity:

• Case of Aerosols (12-1)